Dryer Repair in Dallas
No heat, long dry times, a drum that will not turn or a burning smell. Gas and electric dryers, vent restrictions, heating elements and thermal fuses.
Dryer Repair details
Dallas, Texas · Same-day service · 24/7 emergency
Washer Repair in Dallas, TX
Washers fail in ways that flood laundry rooms. We run washer repair across Dallas with drain pumps, inlet valves, door locks and drive components on the van.
5.0 · 4,455 Google reviews- Licensed & InsuredFully covered work on every job
- Same-Day ServiceMost calls booked within hours
- 24/7 Emergency ServiceNights, weekends and holidays
- 75+ Brands ServicedWhirlpool and GE to Sub-Zero and Miele
Washer Repair
Expert washer repair in Dallas on every major brand
Washer repair in Dallas splits into three buckets: water not arriving, water not leaving, and the drum not doing what it is told. Each has a short list of likely causes, and modern machines usually tell you which bucket you are in through an error code before a technician even arrives.
What they do not tell you is the root cause. A drain error can be a blocked pump, a kinked hose, a failed pressure switch or a control board misreading the level. Our technicians test the circuit rather than replacing the cheapest suspect part first.
Symptoms we see most often
- Drum will not spin, or spins without draining
- Standing water left at the end of the cycle
- Loud banging or walking across the floor on spin
- Door will not unlock after the cycle finishes
- Cycle stopping partway with an error code
- Water leaking from underneath the machine
Front-load washers
Front-loaders in Dallas homes fail predictably: drain pumps clogged with lint and coins, door lock assemblies, boot seals torn at the bottom, and worn bearings that announce themselves as a jet-engine noise on spin. Bearing replacement is the one to think hard about on an older machine, and we will tell you when.
Top-load washers
Top-loaders bring lid switches, shift actuators, drive belts and, on direct-drive platforms, stator and rotor faults. Many of these are quick, inexpensive repairs that get a machine running for years more.
Stop the water first
If your washer is actively leaking, shut off the hot and cold supply valves behind it before you call. That single step is the difference between a repair and a flooring claim. Then call our 24/7 line — leaking washers are treated as emergency appointments.
What a washer repair visit in Dallas looks like
Your technician arrives inside the agreed window, tests the appliance rather than assuming, explains what failed and why, and hands you a written flat-rate price covering parts and labor. You approve it before anything is opened up. Most repairs finish on that first visit, because the parts that fail most often are already on the van.
Afterwards the appliance is run through a full cycle to confirm the fix, the work area is cleaned up, and the workmanship warranty goes on your invoice in writing. If the same symptom returns inside the warranty window, we come back with no labor charge.
Serving Dallas and the wider metroplex
Our Greenville Avenue office covers Dallas, Lakewood, Lake Highlands, Preston Hollow, Highland Park, University Park, Uptown Dallas and Richardson, with four more locations reaching a further fifty cities. Check yours on the service area page.
Brands we carry washer repair parts for
Every brand we repair is serviced by the same Dallas appliance repair team.
Brands we carry washer repair parts for in Dallas
Front-load Samsung and LG machines are the most common washer repair we do in Dallas, and their drain pumps, door lock assemblies and boot seals are permanent stock on our vans. Whirlpool and Maytag top-loaders bring shift actuators, lid locks and drive components, all of which are inexpensive parts on machines that are usually worth saving. Electrolux and Bosch front-loaders we service regularly too. GE and Speed Queen appear less often but are well supported. The one platform we always price carefully is a ten-year-old front-loader with failed drum bearings, because that repair can approach the cost of a replacement machine.
What washer repair in Dallas costs
We quote flat rates, not hourly estimates. The diagnostic fee covers the on-site inspection and is credited toward the repair once you approve it, so you never pay twice to find out what is wrong. The price you approve covers parts and labor for the fault described, and it does not move because the job ran long.
Where a washer repair quote lands depends on the part, not on how long we are in your kitchen. Switches, valves, seals and sensors sit at the affordable end. Control boards, motors and sealed-system work sit at the top. If the number approaches half the price of a comparable new appliance and the unit is past its normal service life, we will say so and tell you what we would buy instead. We would rather turn down one job than sell a repair you regret.
How to avoid your next washer repair call
Most of what we get called out for is preventable, and none of the following requires a technician:
- Leave the door ajar between loads on a front-loader. A sealed damp drum grows the mildew that ruins boot seals and makes laundry smell.
- Clean the drain pump filter behind the lower access panel every few months. Coins and lint collect there and kill pumps.
- Use the correct dose of high-efficiency detergent. Excess suds confuse the pressure sensor and cause phantom drain and spin faults.
- Do not wash single heavy items alone. An unbalanced drum is the leading cause of worn shock absorbers and walking machines.
- Check the fill hoses annually and replace rubber ones with braided stainless. A burst hose on an unattended machine is the most expensive laundry-room failure there is.
Washer Repair across the Dallas–Fort Worth metroplex
Dallas is our largest washer repair market, dispatched from the Greenville Avenue office across Lakewood, Lake Highlands, Preston Hollow, Highland Park, University Park, Uptown Dallas and Richardson. Four more locations extend the same service, the same rates and the same warranty across fifty-seven cities, with no distance surcharge on any of them.
Find your city for local washer repair details: Dallas, Plano, Frisco, McKinney, Allen, Richardson, Garland, Irving, Fort Worth, Rockwall, Wylie, Sachse, Celina, Prosper, Carrollton, Lewisville and fifty more across the metroplex.
If you would rather talk it through than read, calling is faster. A dispatcher answers around the clock and can usually give you an arrival window while you are still on the phone.
On an older front-loader facing a bearing or drum repair, running cost is part of the maths. We will tell you what the repair costs, how much life the machine realistically has left, and whether that money is better put toward a replacement you would keep for another decade.
Related services
Other appliance repairs we handle in Dallas
Booking two appliances on one visit costs you nothing extra when they are at the same address.
Oven Repair in Dallas
Will not heat, uneven baking, a door that will not lock or a failed igniter. Gas and electric, wall ovens, double ovens and built-in units.
Oven Repair detailsQuestions
Washer Repair Dallas — frequently asked questions
Washer repair cost in Dallas: what should I expect to pay?
The service call is $80, which covers the on-site inspection and diagnosis and is credited toward the repair once you approve it. Most washer repairs land in the $150 to $450 range, parts and labor included, though a fault needing an expensive or specialty part can run higher. These are estimate ranges rather than quotes: you get the exact figure in writing before any work starts. Every repair carries a 90-day warranty on parts and labor.
Why does my washer stop mid-cycle?
Most often the machine is waiting on a condition it cannot satisfy: water it is not receiving, water it cannot drain, or a door it cannot confirm is locked. The error code narrows it fast, so note the code before you call.
Is a noisy spin cycle worth repairing?
It depends on the source. An unbalanced load or a worn shock absorber is a cheap fix. Drum bearings on a ten-year-old front-loader are a major job, and we will show you the cost against a new machine before you commit.
Do you repair stacked washer-dryer units?
Yes, including the stacked laundry common in Uptown Dallas and Las Colinas apartments. Tell us it is a stacked unit when booking so we allow time for the unstacking.
How long does a washer repair take?
Typical repairs run one to two hours on site. Pump, valve and door-lock replacements are usually at the shorter end.
Is a washer that will not drain an emergency?
Treat it as one if there is water on the floor. Shut off the hot and cold supply valves behind the machine, then call. A drum full of standing water is not urgent by itself, but a leak reaching a subfloor is.
Why does my front-load washer smell?
Biofilm in the boot seal, the detergent drawer and the drain path. It is a cleaning problem before it is a repair problem, but a torn or badly fouled boot seal does need replacing, and we can do that on the same visit.
How long does a washer repair take in Dallas?
One to two hours on site for most jobs. Drain pumps, inlet valves and door locks sit at the shorter end. Bearing and drum work is a half-day job and we will tell you that before you commit.
Need washer repair in Dallas today?
Book online in under a minute or call and speak to a dispatcher right now. Emergency lines are open 24 hours.